FAQ

Table of Contents

   1. How do I set the time and date on my security system/panel?
   2. I have a trouble light, what does it mean?

How do I set the time and date on  my security system/panel?

To set the system time, enter [*] [6] followed by the master code.  Press [1].  The keypad will now accept 10 consecutive digits:

    - Enter the Time in Hours and Minutes using the 24 hour format (00:00 to 23:59)

    - Enter the Date in Months, Days and Years (MM DD YY)

NOTE: If you have an LCD keypad, your installer may have programmed your system to display the time and date while the keypad is idle.  If this is the case, you may have to press the [#] key to clear the date and time before entering an access code to arm the system, or before programming any keypad functions.
 
Back to FAQ
I have a trouble light, what does it mean?

The following instructions pertain specifically to the DSC 5010 Panel.  Please call SecureTech at (909) 337-1234 for other system information.

The control panel continuously monitors a number of possible trouble conditions.  If one of these trouble conditions occur, the keypad will beep twice every 10 seconds until you press any key on the keypad.

NOTE: A TROUBLE condition reduces the security your system is designed to provide.

To view troubles from an LED Keypad:

    A trouble will be indicated by the Trouble light which will remain ON until the trouble condition is cleared.  If you cannot determine or remedy the cause of the trouble condition, contact SecureTech for assistance.

    To view the type of trouble condition, press [*] [2].  One or more zone lights will turn ON, indicating the various trouble conditions:

 Back to FAQ